4

I recently started working on ARM controllers. I have been using RealView MDK 3.22. However I noticed that, when I was trying to run my simple program involving UART peripheral, it was getting compiled but was not running when downloaded on uC.

The same program started working when I downloaded MDK 3.7. So if your programs are driving you nuts because of some strange reasons, which you are not able to figure out, then update to latest version.

4 Comments

  1. manoj gulati

    hello sir ,
    i had started via proteus it is nice for beginning. can u give some info that hw u burn ur program in arm mcu?? i.e using jtag or any isp ??plz suggest name if any ??

    Reply
    • Elecrom

      If you are using LPC Arm micros, you can burn the programs simply by using small circuit, which connects to serial port. Refer to circuit diagram of MCB2100 board for this connections.

      Reply

  2. sir, i am also an tech freak like you .i had worked on atmega 16 earlier …. now i was thinking to start working on arm mcu’s but i m having least knowledge for that can you suggest some nice book for beginners or some tutorials….if you have read any tut please suggest me….thanks

    Reply
    • Elecrom

      For starting the ARM programming get the following softwares: – Proteus VSM simulator (for simulating arm) – Keil compiler

      There are many simple tutorials available on net for ARM. Try googling and you should get them.

      Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.